1. Explosives shall be fired only with electric detonators of proper strength;

2. Explosives shall be fired with permissible shot-firing units, unless firing is done from the surface when all persons are out of the mine, or in accordance with a plan approved by the Chief;

3. Boreholes in coal shall not be drilled beyond the limits of the cut where the coal is cut nor into the roof or floor;

4. Boreholes shall be cleaned, and shall be checked to see that they are placed properly and are of correct depth in relation to the cut, before being charged;

5. All blasting charges in coal shall have a burden of at least eighteen inches in all directions if the height of the coal permits;

6. Boreholes shall be stemmed with at least twenty-four inches of incombustible material, or at least one-half of the length of the hole shall be stemmed if the hole is less than four feet in depth. The Chief may approve the use of other stemming devices;

7. Examinations for gas shall be made immediately before firing each shot or group of multiple shots, and after blasting is completed;

8. Shots shall not be fired in any place where a methane level of one percent or greater can be detected with a permissible methane detector;

9. Without approval, charges exceeding one and one-half pounds, but not exceeding three pounds, shall be used only if (i) boreholes are six feet or more in depth; (ii) the explosives are charged in a continuous train, with no cartridges deliberately deformed or crushed; (iii) all cartridges are in contact with each other, with the end cartridges touching the back of the hole and the stemming, respectively; and (iv) permissible explosives are used; however, the three-pound limit shall not apply to solid rock work;

10. Any solid shooting shall be done in compliance with conditions prescribed by the Chief;

11. Shots shall be fired by a certified underground shot firer;

12. Boreholes shall not be charged while any other work is being done at the face, and the shot or shots shall be fired before any other work is done in the zone of danger from blasting except that which is necessary to safeguard the miners;

13. Only nonmetallic tamping bars, including a nonmetallic tamping bar with a nonsparking metallic scraper on one end, shall be used for charging and tamping boreholes;

14. The leg wires of electric detonators shall be kept shunted until ready to connect to the firing cable;

15. The roof and faces of working places shall be tested before and after firing each shot or group of multiple shots;

16. Ample warning shall be given before shots are fired, and care shall be taken to ascertain that all miners are in the clear;

17. All miners shall be removed from the working place and the immediately adjoining working place or places to a distance of at least 100 feet and accounted for before shots are fired;

18. Mixed types or brands of explosives shall not be charged or fired in any borehole;

19. Adobe (mudcap) or other open, unconfined shots shall not be fired in any mine except those types approved by the Mine Safety and Health Administration and the Chief;

20. Power wires and cables that could contact blasting cables or leg wires shall be de-energized during charging and firing;

21. Firing shots from a properly installed and protected blasting circuit may be permitted by the Chief;

22. No miner shall return, or shall be allowed to return, to the working place after the firing of any shot or shots until the smoke has reasonably cleared away;

23. Before returning to work and beginning to load coal, slate or refuse, a miner shall make a careful examination of the condition of the roof and do what is necessary to make the working place safe; and

24. An examination for fire shall be made of the working area after any blasting.